Procentec ComBricks User Manual

ComBricks User Manual v6.4.0 | January 18| © PROCENTEC 164/219
Technical Data - SCOPE Repeater (101-201210)
Dipswitches
NW0 NW1
LEFT LEFT
RIGHT LEFT
LEFT RIGHT
RIGHT RIGHT
RED
LEFT / RIGHT
H/S
LEFT / RIGHT
PROFIBUS Network
1
2
3
4
Redundancy
OFF / ON
Settings
Hardware / Software
PROFIBUS connectors
CH1
A, B
SH
I
Screw terminals + DB9 connector (1-on-1)
Green wire, Red wire
Direct grounding
Indirect grounding
LEDs
RX
SW
HWE
ER
MIN
TERM
Receiving telegrams (blinking)
Termination ON
Internal repeater error (contact PROCENTEC)
No or bad telegrams detected
Signal amplitude of the telegrams too low (< 2.5 V)
Idle voltage too low ( <0.95 V .. >1.26 V )
The alarm values be changed through the web server.
Others
Head Station firmware
Operating temperature
Weight
MTBF
At least version 1.260
0 .. 60 °C
120 g
To be defined
Dipswitches or web
server settings
Redundancy for the
current network
Communication
error or bad
telegrams
Termination ON
Data received
Repeater Module
status
Network 1: NW0 = L, NW1 = L
Network 2: NW0 = R, NW1 = L
Network 3: NW0 = L, NW1 = R
Network 4: NW0 = R, NW1 = R
Repeater internal
failure
The idle voltage
when nobody is
sending is too low
Signal amplitude of
the telegrams
is too low

Procentec ComBricks Specifications

General

Brand	Procentec
Model	ComBricks
Category	Switch
Language	English