R&S RTC1000 - Page 224

Remote Commands Reference
R&S
®
RTC1000
224User Manual 1335.7352.02 ─ 02
Suffix:
<m>
.
1..6
Selects the measurement place.
Parameters:
<SignalSource> NONE | CH1...CH2 | QMA | RE1...RE4 | POD | D0..7 | TRIGger |
EXTern
*RST: CH1
<ReferenceSource> NONE | CH1...CH2 | QMA | RE1...RE4 | POD | D0..7 | TRIGger |
EXTern
CH1 | CH2
Active signal channels 1 to 2.
QMA
Active quick math channel QMA.
RE1...RE4
Active reference channels RE1 to RE4.
POD
Active logic POD.
D0...D7
Active digital channels D0 to D7.
TRIGger
TRIG is returned, if the measurement type is a trigger measure-
ment source (TFRequency, TPERiode).
EXTern
Active external signal.
MEASurement<m>:CATegory?
Returns the measurement category.
Suffix:
<m>
.
1..6
Selects the measurement.
Return values:
<Category> AMPTime | SPECtrum
AMPtime
Yt-measurements
SPECtrum
Spectrum measurements
*RST: AMPT
Usage: Query only
MEASurement<m>:MAIN <MeasType>
Defines the measurement type to be performed on the selected source. To query the
results, use MEASurement<m>:RESult?.
Measurements