R&S RTC1000 User Manual

Remote Commands Reference
R&S
®
RTC1000
223User Manual 1335.7352.02 ─ 02
MEASurement<m>:AON
Starts the quick measurement.
Suffix:
<m>
.
1 (the suffix is irrelevant)
Usage: Event
MEASurement<m>:ARESult?
Returns the results of the quick measurement.
Suffix:
<m>
.
1 (the suffix is irrelevant)
Return values:
<QuickMeasData> List of values
Quick measurement results are listed in the following order:
PEAK, UPE, LPE, CYCR, CYCM, PER, FREQ, RTIM , FTIM
Usage: Query only
13.6.3 Automatic Measurements
MEASurement<m>[:ENABle]...........................................................................................223
MEASurement<m>:SOURce........................................................................................... 223
MEASurement<m>:CATegory?....................................................................................... 224
MEASurement<m>:MAIN................................................................................................224
MEASurement<m>:RESult?............................................................................................227
MEASurement<m>:DELay:SLOPe...................................................................................228
REFLevel<m>:RELative:MODE.......................................................................................228
MEASurement<m>[:ENABle] <State>
Activates or deactivates the selected measurement (1-6). Only the results of active
measurements are displayed in the result table.
Suffix:
<m>
.
1..6
Selects the measurement.
Parameters:
<State> ON | OFF
*RST: OFF
MEASurement<m>:SOURce <SignalSource>[,<ReferenceSource>]
Selects one of the active signal, reference or math channels as the source(s) of the
selected measurement. Available sources depend on the selected measurement type.
Measurements

R&S RTC1000 Specifications

General

Brand	R&S
Model	RTC1000
Category	Test Equipment
Language	English