Range Rover Evoque - ROLLING RE-START; KEYLESS START BACKUP

If the brake pedal is pressed when
the engine START/STOP button is
pressed, the engine will start.
Manual transmission: Make sure that
a valid Smart key is inside the vehicle,
and that the clutch pedal is not
pressed.
If the clutch pedal is pressed when
the engine START/STOP button is
pressed, the engine will start.
2. Press and hold the engine START/
STOP button until the Instrument
panel warning lamps illuminate.
3. Release the engine START/STOP
button.
ROLLING RE-START
If the engine is switched off while the
vehicle is moving, a rolling restart can be
initiated by:
• Automatic transmission: Selecting
Neutral (N) and pressing the engine
START/STOP button.
• Manual transmission: Firmly pressing
the clutch pedal, and simultaneously
pressing the engine START/STOP
button.
Note: The engine START/STOP button is
inhibited for 2 seconds after the engine
has been switched off.
KEYLESS START BACKUP
If the vehicle is unlocked using the
emergency key blade, or the Smart key is
not detected by the vehicle, it will be
necessary to use the Keyless start backup
feature to disarm the alarm and start the
engine.
The Keyless start backup feature can only
be used when the message Smart Key
Not Recognised - Reposition or Place As
Shown and Press Start Button is
displayed in the Message centre.
1. Position the Smart key flat against the
underside of the steering column, with
the buttons facing downwards.
Note: There are markings on the
steering column to help locate the
correct position.
2. While holding the Smart key in
position:
Automatic transmission: Firmly press
the brake pedal.
Manual transmission: Firmly press the
clutch pedal.
3. Press and release the engine START/
STOP button.
101
Starting the engine
R
© Jaguar Land Rover Limited 2015