Range Rover Evoque - TIMED CLIMATE REMOTE CONTROLS

Note: The time format, 12/24 hour clock,
is determined by the time settings
currently selected in the SYSTEM
SETTINGS menu. See 81, SYSTEM
SETTINGS.
A current heating cycle will be cancelled
if the engine is started. Any programmed
heating cycle may be cancelled by
touching the relevant soft key (1 or 2) on
the timer setup menu.
TIMED CLIMATE REMOTE
CONTROLS
The Timed climate remote control has an
approximate range of 100 metres. There
is no need to point the antenna at the
vehicle.
1. ON button.
2. OFF button.
3. LED (operation indicator).
4. Antenna.
Note: Avoid touching the antenna
when operating the ON or OFF
buttons.
Press and hold the ON button for
approximately 2 seconds. The LED will
illuminate to confirm that an automatic
heating program has been initiated. The
LED flashes once every 2 seconds to
indicate that the heater is active.
The heating program will continue for
20-30 minutes, when it will switch off
automatically to prevent the vehicle's
battery from discharging. It also switches
off automatically if the engine is started.
The LED indicator signals various states
and conditions for the heater as follows:
• Illuminates red for 2 seconds when the
OFF button is pressed, to indicate that
the program has stopped.
• Flashes green or red for 2 seconds
then stops when the ON or OFF
buttons are pressed, to indicate that
no action has been taken.
• Illuminates orange for 2 seconds
before showing green or red, to
indicate that the remote battery is low.
• Flashes orange for 5 seconds to
indicate that no action has been taken
and the remote battery should be
replaced.
Additional remotes
Extra remote controls can be programmed
to operate the heater. A maximum of 3
remote controls can be programmed to
each vehicle. Contact a Retailer/
Authorised Repairer to purchase extra
remote controls and have them
programmed to the vehicle.
87
Heating and ventilation
R
© Jaguar Land Rover Limited 2015