Once any obstructions have been
removed, the seat adjustment mechanism
can be reset as follows:
Operate the button again to continue the
stalled adjustment. When seat movement
resumes, hold the button until the end of
travel in that direction has been reached.
Seat adjustment can now be carried out
as normal.
Note: If no obstructions can be seen, but
normal adjustment cannot be carried out
without stalling, contact your Retailer/
Authorised Repairer.
SITTING IN THE CORRECT
POSITION
The driver and front seat
passenger must not ride with the
seat fully reclined.
Do not adjust the seat while the
vehicle is moving.
The seat, head restraint, seat belt and
airbags, all contribute to the protection of
the user. Correct use of these components
will give you greater protection. Therefore,
you should always observe the following
points:
1. Sit in an upright position, with the base
of your spine as far back as possible.
To achieve optimum benefit of the
seat belt in the event of an accident,
do not recline the seat excessively.
2. Do not move the driver's seat too
close to the steering wheel. Ideally, a
minimum distance of 254 mm is
recommended between the
breastbone and the steering wheel
airbag cover. Hold the steering wheel
in the correct position, with your arms
slightly bent.
3. Adjust the head restraint so that the
top of the head restraint is above the
centre line of the head.
4. Position the seat belt so that it is
midway between your neck and your
shoulder. Fit the strap tightly across
your hips; not across your stomach.
Make sure that your driving position is
comfortable and enables you to maintain
full control of the vehicle.
DRIVING POSITION MEMORY
The front seat positions can be saved to
the vehicle's memory.
Once you have adjusted the power
operated driver’s seat and the exterior
mirrors (see 69, EXTERIOR MIRRORS),
the vehicle can memorise the settings for
future use.
22
Front seats
© Jaguar Land Rover Limited 2015
To Next Page
Loading...
