6. Emergency key access: Slide open the
side cover to release, then remove.
7. Remove the emergency key blade and
unfold.
8. If the Smart key fails to open the
vehicle, insert the key blade into the
slot at the base of the driver's door
lock cover. Apply slight downward
pressure to the top of the cover and
gently lever the key blade upwards.
Carefully rotate the door lock cover
upwards, to lever the cover off the
retaining lugs.
9. Insert the key blade into the exposed
lock and turn to operate the lock. The
alarm sounds until the Smart key is
positioned correctly, to disarm the
alarm: see 101, KEYLESS START
BACKUP.
Note: When replacing the door lock
cover, locate the top retaining lugs
first. Press down and inwards to locate
the single bottom lug. The lug clicks
into the locked position. Check the
security of the cover. An insecure cover
is likely to fall off while the vehicle is
moving.
10.Keyless entry/exit: Exterior door
handles have separate unlock and lock
sensors. The unlock sensor is located
on the inner surface of the handle.
Note: A replacement Smart key can be
obtained only from a Retailer/Authorised
Repairer. The Retailer/Authorised Repairer
will require proof of identification and
ownership.
Notify your Retailer/Authorised Repairer
immediately if a Smart key is lost or stolen.
SINGLE/MULTI-POINT ENTRY
Press the unlock button; the vehicle
unlocks in one of two ways:
1. Single-point entry: On the first press,
the driver's door unlocks. If a locking
fuel filler flap is fitted, it also unlocks.
A second press is required to unlock
the remaining doors and luggage area.
2. Multi-point entry: On the first press,
all of the doors, the fuel filler flap and
the luggage area unlock.
To change from Single to Multi-point entry
(or vice versa), press both the lock and
unlock buttons simultaneously for three
seconds. The hazard warning lamps flash
twice to confirm the change.
This feature may also be set via Vehicle
Set-up in the Instrument panel menu. See
49, INSTRUMENT PANEL MENU.
Note: If an audible warning is emitted
when the vehicle is unlocked, there may
be a fault with the alarm sensors. Consult
a Retailer/Authorised Repairer as soon as
possible.
GLOBAL OPENING
Press and hold the Smart key unlock
button for three seconds to unlock the
vehicle and open all of the windows.
To cancel Global opening, press any of
the buttons on the Smart key or operate
the driver’s window switches. To stop a
particular window opening, operate the
relevant window switch.
Note: Global opening can be enabled
and disabled via the Instrument panel
menu. See 49, INSTRUMENT PANEL
MENU.
6
Entering the vehicle
© Jaguar Land Rover Limited 2015
To Next Page
Loading...
