1. Lock: Press to secure the vehicle. The
vehicle Single locks. In some markets,
a second press Double locks the
vehicle. See 15, SINGLE LOCKING,
15, DOUBLE LOCKING. If Power-fold
mirrors are fitted and enabled, they
fold in. See 69, EXTERIOR MIRRORS.
Press and hold to activate Global
closing. See 17, GLOBAL CLOSING.
2. Unlock: Press briefly to unlock the
vehicle and deactivate the alarm. The
hazard warning lamps flash twice to
indicate that the vehicle is unlocked
and the alarm is deactivated. The
interior lamps illuminate to assist entry
to the vehicle.
If Power-fold mirrors are fitted and
enabled, they unfold. Press and hold
to activate Global opening. See 6,
GLOBAL OPENING.
3. Luggage compartment: Press briefly
to release/open the Luggage
compartment. If the vehicle is locked
and armed, all other doors remain
closed and the exterior alarm remains
active while the vehicle is open, but
intrusion and inclination sensing
systems are disabled until the vehicle
is closed again.
When closing, if the vehicle is already
locked and armed, the hazard warning
lamps flash after a few seconds to
confirm that the full alarm system is
reactivated. An audible sound is given
when the vehicle is double locked. See
8, OPENING AND CLOSING THE
TAILGATE. See also 10, OPENING
AND CLOSING THE POWERED
TAILGATE.
Note: Make sure the Smart key does
not remain in the vehicle prior to
closure. It may not be detected if it is
placed inside a metal container, if it is
shielded by a device with a back-lit
LCD screen, (e.g., laptop, smartphone,
etc.), or if the vehicle is in an area of
localised Radio Frequency (RF)
interference. If the Smart key is not
detected inside the vehicle, the vehicle
allows locking to take place. The
vehicle does NOT automatically
unlock. The vehicle now unlocks only
with another valid Smart key.
4. Panic alarm:
• Press and hold for three seconds
(or press three times within three
seconds) to activate the horn and
the hazard lamps.
• Once active for more than five
seconds, the alarm can be
cancelled by pressing the button
and holding for three seconds (or
pressing three times within three
seconds).
• The panic alarm is also cancelled
if a valid Smart key is present when
the START/STOP button is
pressed.
5. Approach illumination:
• When approaching the vehicle
during darkness, press to switch on
the approach illumination. Press
again to switch the approach lamps
off.
• The approach illumination pre-set
delay period, is 30 seconds. This
delay period can be configured to
provide illumination lasting
between 0 and 240 seconds. See
49, INSTRUMENT PANEL MENU.
5
Entering the vehicle
© Jaguar Land Rover Limited 2015
To Next Page
Loading...
