Range Rover Evoque - PROGRESS CONTROL SYSTEM SETTINGS

The Progress control system can also be
enabled by pressing and releasing the
button while the vehicle is moving, without
the need to stop or apply the brake pedal.
The current vehicle speed will then be
used as the set speed and the Progress
control system will then default to the full
function mode.
Note: If the vehicle's brakes are firmly
applied, during the operation of Progress
control, the system will exit the full
function mode and will then enter into the
descent control mode.
Note: Light and gentle application of the
brake pedal, during the operation of
Progress control, will lower the target
vehicle speed. When the brake pedal is
fully released, the Progress control system
will maintain the speed at which the brake
pedal was released.
Note: The driver can override the Progress
control system at any time, with the use
of the brake pedal or the accelerator
pedal.
Note: If the vehicle's speed exceeds 30
km/h (18.6 mph), the Progress control
system will be suspended, and the system
will then go into a standby mode, until the
vehicle's speed is less than 30 km/h (18.6
mph).
Note: If the vehicle's speed exceeds 80
km/h (50 mph), the Progress control
system will be disabled. If required, the
system will have to be switched on again,
via the Progress control button.
The driver must maintain full control
of the steering and brakes at all
times.
When the Progress control system is
enabled and the brake pedal is fully
released, the system will help to provide
controlled and progressive assistance for
the vehicle to;
• Pull-away from stationary in a forward
or reverse direction on level ground,
and uphill or downhill.
• Perform low speed manoeuvring in a
forward or reverse direction.
• Make progress and maintain a selected
target (set) speed, up to a maximum
of 30 km/h (18.6 mph).
In the event that the vehicle's brake
temperatures exceed the normal
operating limits, a warning message will
be displayed in the Message centre
stating that the system will be temporarily
unavailable. The Progress control system
will then fade-out and become temporarily
inactive. Once the brakes have returned
to the normal operating temperatures, the
message will extinguish and the Progress
control system will resume normal
operation, if still required.
Do not attempt a steep descent if
the Progress control system is not
enabled or the warning message is
displayed.
PROGRESS CONTROL SYSTEM
SETTINGS
When the Progress control system is
enabled, the desired target (set) speed for
the vehicle can be set and adjusted via
the Cruise control buttons, mounted on
the right side of the steering wheel. See
128, USING CRUISE CONTROL.
138
Progress control system
L
© Jaguar Land Rover Limited 2015