Range Rover Evoque - REPROGRAMMING A SINGLE GARAGE DOOR OPENER BUTTON; TO ERASE ALL PROGRAMMING; INFORMATION AND ASSISTANCE

To operate the remote device, press and
hold the programmed memory button on
the RF transceiver for 2 seconds. If the LED
illuminates continuously, the RF transceiver
has been programmed successfully, and
the remote device will operate.
Note: You may need to press the button
on the RF transceiver up to 3 times.
If the remote device does not operate,
and the LED flashes quickly, further
programming will be required.
These additional programming steps may
require assistance from another person.
1. Locate the smart/learn program
button on the remote device you wish
to program.
Note: The name and location of this
button may vary, depending on the
manufacturer of the remote device.
2. Press and release the smart/learn
program button, and within 30
seconds, press and hold the desired
memory button on the RF transceiver
for 2 seconds.
Note: You may need to press and hold
the memory button on the RF
transceiver for 2 seconds, a further 2
times.
Note: Some entry gate systems require
you to cycle (press and re-press) the
hand-held transmitter every 2 seconds
during programming. If this is the case,
continue to press and hold the memory
button on the RF transceiver until the LED
flashes quickly.
The RF transceiver should now be
programmed. Repeat the programming
steps, if you wish to add further remote
devices to the RF transceiver.
To operate a programmed remote device,
press and hold the relevant memory
button on the transceiver. Release the
button when the device starts operating.
REPROGRAMMING A SINGLE
GARAGE DOOR OPENER
BUTTON
To program a remote device to a
previously programmed RF transceiver
memory button:
1. Press and hold the desired RF
transceiver memory button. After
approximately 20 seconds, the LED
will start to flash slowly.
2. Follow the instructions described in
step (2) onwards, as described in
PROGRAMMING.
TO ERASE ALL PROGRAMMING
To erase all programming from the RF
transceiver:
1. Switch the vehicle’s ignition on.
2. Simultaneously press and hold memory
buttons 1 and 3 on the RF transceiver.
After approximately 10 seconds, the RF
transceiver LED will start to flash. At this
point, release both memory buttons on
the RF transceiver. All programming will
have now been erased from the RF
transceiver.
Note: Do not press and hold the buttons
for longer than 20 seconds.
INFORMATION AND
ASSISTANCE
It is recommended that when you
sell the vehicle, you erase all
programming from the RF
transceiver.
76
Garage door opener
L
© Jaguar Land Rover Limited 2015