Range Rover Evoque - INSTALLING TETHER ANCHORAGE CHILD RESTRAINTS

WARNING: child restraint
anchorages are designed to
withstand only those loads
imposed by correctly fitted child
restraints. Under no circumstances
are they to be used for adult seat
belts, harnesses, or for attaching
other items or equipment to the
vehicle.
ISOFIX anchorages are provided at the
outer seat positions on the second row
seats.
To install an ISOFIX child seat:
1. Locate the ISOFIX anchor bars and, if
fitted, remove the covers.
2. Slide the child seat into position and
attach the locking mechanism to the
ISOFIX anchor bars.
3. If an upper tether is fitted to the child
seat, make sure it is properly secured
to the upper tether anchorages on the
rear of the seats.
If an upper tether is fitted to the child seat,
see 40, INSTALLING TETHER
ANCHORAGE CHILD RESTRAINTS.
Test the security of the child restraint. To
do this, attempt to pull the restraint away
from the vehicle seat and twist the
restraint from side to side. Even if the
restraint appears secure, you should still
check the anchor points visually, to make
sure they are correctly attached.
Note: Always make sure that if an upper
tether is provided, it is fitted and
tightened correctly.
INSTALLING TETHER
ANCHORAGE CHILD
RESTRAINTS
Always follow the child seat or
restraint system manufacturer’s
instructions when fitting tether
straps.
When fitting a child seat or
restraint system, always pass the
tether strap over the top of the
seatback and beneath the head
restraint.
If removing a head restraint in
order to fit a child restraint,
always secure the head restraint
when storing it.
If a child seat or restraint system
is to be fitted to the centre
seating position, the centre
armrest must be in the stowed
position (folded into the seat).
40
Child safety
L
© Jaguar Land Rover Limited 2015