Anti-trap protection will stop window or
roof blind movement if an obstruction or
resistance is detected. Check the window
or roof blind, and its aperture, and remove
any obstructions (e.g., ice, etc.).
If it is still necessary to raise the window,
the override procedure is as follows:
1. Attempt to close the window; anti-trap
will prevent closure and lower the
window slightly.
2. Within ten seconds, attempt to raise
the window again; anti-trap will
prevent closure and lower the window
slightly.
3. Attempt to close the window for a
third time, this time hold the switch in
the close position. Hold until closed.
Note: If this procedure fails to remove
the blockage, the window operation may
need to be reset. See 209, WINDOW
RESET.
SOLAR ATTENUATING GLASS
This type of windscreen filters sunlight
passing through a special laminated layer.
Electronic actuating cards, such as toll
road payment cards or Radio Frequency
(RF) ID tags, can be fixed at the dedicated
locations on the inside of the windscreen.
If these cards are located at any other part
of a solar attenuating windscreen, the
electronic scanners may not recognise
them.
The fixing location is at the top of the
windscreen, close to the interior rear-view
mirror.
Note: It is recommended that the
electronic actuating card should be in the
size appropriate location, on the driver's
side of the windscreen.
Note: Transponders, mounted on the
front number plate plinth, can be used as
an alternative, dependent on the market
and availability.
79
Windows
© Jaguar Land Rover Limited 2015
To Next Page
Loading...
