TYRE PRESSURE CHECK
The Instrument panel can be used to
display the vehicle’s tyre pressures. The
tyre pressure figures can be accessed via
the Vehicle Info menu.
For more information, see 49,
INSTRUMENT PANEL MENU.
Note: The tyre pressure units can be
configured to display as either bar, psi, or
kPa via the Vehicle Info and the Tyre
Information menus.
When selected, the last known tyre
pressures will be displayed, alongside the
recommended cold tyre pressures (in
brackets).
Note: If any of the wheels or tyres have
been removed, the displayed tyre
pressures may not be valid. Drive the
vehicle for at least 15 minutes in order to
re-calibrate the system.
RECOMMENDED TYRE
PRESSURE LOOK-UP
The Instrument panel can be used to
display the recommended cold tyre
pressures for your vehicle. The tyre
pressure look-up table can be accessed
via the Vehicle Info and the Tyre
Information menus.
For more information, see 49,
INSTRUMENT PANEL MENU.
Depending on the specification of your
vehicle, a number of different values may
be displayed to reflect different driving
conditions, for example, high speed
driving or for a heavily laden vehicle.
VEHICLE LOADING
The TPMS can be adjusted to monitor
either Normal (light) load or Heavy load,
via the Instrument panel menus, Vehicle
Info, Tyre Information and TPM Load
Setting. See 49, INSTRUMENT PANEL
MENU.
Note: The ignition will have to be
switched on, without the engine running.
If the tyre pressures are adjusted to the
Normal (light) load setting, then the TPMS
should be adjusted to suit the vehicle's
load and associated recommended tyre
pressures.
Every time the ignition is switched on, a
TPMS message will be displayed in the
Message centre, to indicate which load
setting is being monitored.
Note: The TPMS setting must correspond
with the vehicle's current load.
The Normal (light) load setting should be
used during normal use of the vehicle, for
example, up to 4 occupants.
The Heavy Load setting should be used
when the vehicle’s load exceeds normal
use, and up to the Gross Vehicle Weight
(GVW), for example, more than 4
occupants.
Note: Make sure that the tyre pressures
are correct for the vehicle's current load.
The Instrument panel menus, Vehicle Info
and Tyre Pressures, can be used to check
the vehicle's current tyre pressures.
244
Tyre pressure monitoring system (TPMS)
© Jaguar Land Rover Limited 2015
To Next Page
Loading...
