7. Rear fog lamps: Will operate only while
side lamps, headlamps or Auto lamps
are selected. Turn the collar towards
the steering wheel and release. The
Instrument panel warning lamp will
illuminate. See 57, REAR FOG LAMP
(AMBER).
To switch off the rear fog lamps: Turn
the collar towards the steering wheel
again and release.
In the event of a bulb failure, it should be
noted that some bulbs are renewable only
by a Retailer/Authorised Repairer. See 202,
CHANGING A BULB.
DAYTIME RUNNING LAMPS
With the lighting control in the OFF
position or in the AUTO position, while
the lighting conditions do not require the
headlamps to be on, then the Daytime
running lamps will switch on automatically
under the following conditions:
• The engine is running.
• The gear selector is out of Park (P)
(automatic transmission).
• The Electric Parking Brake (EPB) is not
applied - market dependent.
Unless required or prohibited
by law, the Daytime running
lamps feature can be disabled
or enabled by a Retailer/
Authorised Repairer.
HEADLAMP COURTESY DELAY
This feature operates whenever the
lighting control is in the auto position and
the ignition is switched off. The headlamps
will remain illuminated for up to 240
seconds.
Note: The time delay may be changed via
the Vehicle Set-Up menu. See 49,
INSTRUMENT PANEL MENU.
The Courtesy delay can be switched off
at any time, by pressing the headlamp
button on the Smart key.
AUTO HIGH BEAM
This feature automatically selects and
deselects the high beam, under specific
conditions of road lighting and in the
absence of other vehicle’s lights. The
system is only active when the ambient
light drops below a predetermined level.
Note: It is not recommended that Auto
high beam is used while driving off road.
For Auto high beam to become
operational, the lighting control must be
in the AUTO (5) position, with dipped
beam headlamps selected.
The Instrument panel warning lamp
illuminates when Auto high beam is
selected. See 57, AUTO HIGH BEAM
(GREEN).
Auto high beam will only activate when
the vehicle's speed exceeds 40 km/h (25
mph). The system will deactivate when the
vehicle's speed drops below 24 km/h (15
mph).
To manually select high beam, move the
lighting control to the high beam position
as normal. To return to Auto high beam,
move the lighting control back to the
central position.
To manually override to dipped beam
from high beam, pull the lighting control
to the flash position (2) and Auto high
beam will be cancelled. To return to Auto
high beam, push the lighting control to
the high beam position (1) and then return
it to the central position.
60
Exterior lights
© Jaguar Land Rover Limited 2015
To Next Page
Loading...
