3. Push in the release mechanism while
pulling the connector and bulb holder
apart.
Note: Inside the bulb holder are 3 locating
lugs. When fitting the new bulb unit, the
lugs must mate up to the connector
correctly.
Refitting is a reverse of the removal
process. Make sure the connector lock is
pressed down and that the bulb unit
locates securely into the fog lamp housing.
WIPERS SERVICE POSITION
To avoid damage to the bonnet, do
not lift the wiper blades when they
are in the normal parked position.
Note: The Smart key must remain in the
vehicle while the wiper blades are
replaced.
Before changing a wiper blade, the wiper
arms must be set in the 'service' position
as follows:
1. Make sure the ignition is switched off.
2. Switch the ignition on and then off
again.
3. Immediately press the wiper/washer
control to its lowest position (as if to
command a single wipe, see 65,
WIPER OPERATION), hold this
position while switching on the ignition
again.
The wipers will move to their service
position.
4. When the new parts have been fitted,
switch the ignition off. This will return
the wipers to the park position.
Note: Fit only replacement wiper blades
that are identical to the original
specification.
Note: Replace the wiper blades in
accordance with manufacturer's
instructions.
WINDOW RESET
The windows will need to be reset if the
battery is disconnected, becomes
discharged, or power supply is
interrupted.
209
Maintenance
© Jaguar Land Rover Limited 2015
To Next Page
Loading...
