3. Press and hold the tailgate close switch
for 10 seconds to set the required
opening height.
4. Close the tailgate, then open again to
check that it opens to the set height.
Note: If, after performing part 3 of the
process, the tailgate closes automatically,
the required height has not been set.
Repeat the process, making sure that all
steps are adhered to.
To reset the maximum opening height,
repeat the process, but when the tailgate
reaches its current set height, manually
move it to the fully open position, before
pressing and holding the button.
The powered tailgate may lose its position
memory if there are multiple object
detections or, if the battery voltage is low.
Powered operation may be inhibited.
To reset the tailgate:
1. Manually close the tailgate.
2. Press a release switch.
3. Allow the tailgate to power fully open,
or to the previously set position.
4. Press and release the close switch.
5. Allow the tailgate to power close fully.
The tailgate's programmed memory
is now restored.
SMART KEY BATTERY
REPLACEMENT
When the battery needs replacing, there
is a significant decrease in the effective
range and SMART KEY BATTERY LOW
is displayed in the Message centre.
To replace the battery:
1. Remove the cover by sliding in the
directions of the arrows.
2. Use the emergency key blade to
separate the Smart key body.
3. Fit a new and unused CR2032 type
battery (available from a Retailer/
Authorised Repairer) with the positive
(+) side upwards.
Note: Avoid touching the new battery.
Moisture/oil from fingers can reduce
battery life and corrode the contacts.
13
Entering the vehicle
© Jaguar Land Rover Limited 2015
To Next Page
Loading...
