To switch Auto high beam off, turn the
lighting control from AUTO to headlamps.
This feature can be disabled/enabled via
the Vehicle Set-Up menu. See 49,
INSTRUMENT PANEL MENU.
The following may affect the operation of
Auto high beam:
• Highly reflective road signs.
• Dimly lit road users, for example,
cyclists or pedestrians.
• Adverse weather conditions, for
example, rain or fog.
• Dirty or obscured sensor.
• Dirty, damaged or misted windscreen.
• Oncoming vehicles partially obscured
by a central motorway barrier.
• An icy or frosted windscreen.
Note: Make sure to defrost the
windscreen during winter conditions.
Note: The system cannot be relied upon
to activate or deactivate high beam in all
possible circumstances. It remains the
driver’s responsibility to use the
headlamps correctly at all times.
Note: Make sure that the forward-facing
sensors on the back of the rear-view mirror
are not blocked or obstructed.
WINDSCREEN WIPER
DETECTION
If Auto lamps is selected and the
windscreen wipers are switched on for 20
seconds or more, the side lamps, tail
lamps and headlamps will switch on
automatically. When the wipers are
switched off, the lamps will automatically
switch off 2 minutes later.
HEADLAMPS - CONDENSATION
Misting of lamp lenses can occur under
some atmospheric conditions. This will not
affect the performance of the lamps and
will clear during normal operation.
HEADLAMPS - DRIVING
ABROAD
The headlamp beam pattern is suitable
for driving on either side of the road.
There is no need for any mechanical
adjustment or external decals.
HEADLAMP LEVELLING
Use the headlamp levelling control to
account for vehicle loading changes.
Switch positionVehicle load
TopDriver only
TopDriver and front
seat passenger
Rotate down 1
notch
Driver and
passengers in all
seats
Rotate down 1
notch
Maximum gross
vehicle weight
Rotate down 2
notches
Maximum rear axle
load
61
Exterior lights
© Jaguar Land Rover Limited 2015
To Next Page
Loading...
