RADIO FREQUENCY
TRANSCEIVER
In some countries, the Radio Frequency
(RF) transceiver is also known as the
HomeLink® Universal Transceiver.
The RF transceiver is located in the
rear-view mirror. It can be programmed
to transmit the signals of up to 3 different
hand-held transmitters. These can be used
to operate garage doors, entry gates,
home lighting, security systems, or other
RF-operated remote devices.
Do not use the RF transceiver with
any garage door opener that lacks
the safety stop and reverse
feature, as required by safety
standards.
When programming the RF
transceiver to a garage door
opener or entry gate, make sure
that the area is clear of people
and objects. This will prevent
potential harm or damage, as the
gate or garage door will activate
during programming.
This device may suffer from
interference, if operated in the
vicinity of a mobile or fixed station
transmitter. This interference is
likely to affect the hand-held
transmitter, as well as the RF
transceiver.
For further information, see 76,
INFORMATION AND ASSISTANCE.
BEFORE PROGRAMMING
When programming a remote
device that may require you to
press and re-press the hand-held
transmitter, unplug the device
during the programming process,
to prevent possible motor failure.
For best results, fit a new battery to the
hand-held transmitter before
programming. If the remote device’s
receiver is equipped with an antenna,
make sure the antenna is extended.
PROGRAMMING
To program the RF transceiver:
1. Switch the vehicle’s ignition on.
2. Position the hand-held transmitter 25
to 75 mm from the rear-view mirror.
3. Simultaneously press and hold the
memory button on the hand-held
transmitter, and the desired memory
button on the RF transceiver. An
indicator LED, located on the left side
of the mirror, will start flashing slowly.
4. When the LED starts flashing quickly,
release both buttons.
75
Garage door opener
© Jaguar Land Rover Limited 2015
To Next Page
Loading...
