SERVICE PROGRAM TABLES
SM 5-29 B132/B200
Service Tables
1110 Paper Type Selet Paper Type Select
These SP settings switch the on/off the paper type type detection and double-feed
functions.
[0~1/1]
0: Enable
1: Disable
Two sensors, one mounted above and one below the paper at the registration
rollers, detect the opacity of the first sheet and compares this reading for every
subsequent sheet. If the reading is higher (thicker paper) or lower (thinner paper)
the sensor triggers an error.
Paper Type
001 Tray 1
002 Tray 2
003 Tray 3
004 Tray 4 Japan Only
005 Bypass
006 LCT
Double-Feed
007 Tray 1
008 Tray 2
009 Tray 3
010 Tray 4 Japan Only
011 Bypass
002 LCT
1111 Nip Width Mode Nip Width Measurement Setting Mode
001 Execute
Determines whether the nip at the hot roller and pressure
roller is calibrated. Touch [Execute].
002 Stop Time
Determines the down time of the fusing/exit motor in the
fusing nip band calibration mode.
[1~100/1 sec.]
003 Stop Interval
Determines the intervals between the down times of the
fusing/exit motor in the nip band calibration mode.
[0~2000/100 msec.]
1112 Fuser Unit In/Out Fusing Unit: In/Out – Start Fusing Unit
Determines whether the fusing unit operates during the copy cycle for image
creation and paper feed.
0:OFF, 1:ON
To Next Page
Loading...
