21 August 2006
3-60
AREA C
Removal
1. Remove Fold transmission belt (
3.6.7 ).
2. Remove screw and washer [A] (
x1, x1 ).
3. Remove bearing [B].
4. Remove the Motor transmission pulley [C].
5. Remove screws [D] (
x3 ).
Replacement
1. Reinstall screws [D] (
x3 ).
NOTE: DO NOT TIGHTEN THE SCREWS.
2. Reinstall the Motor transmission pulley [C].
3. Reinstall screw and washer [A] (
x1, x1 ).
4. Reinstall Fold transmission belt.
5. Reinstall Fold roller sensor Q9 plate.
NOTE: make sure that the sensor plate is correctly installed.
6. Reinstall the Fold transmission plate.
NOTE: Make sure that the at of the ange bushing, correspond to the at on
the Fold transmission plate.
7. Reinstall screws to the Fold transmission plate (
x3 ).
NOTE: Tighten the Fold transmission belt before tightening the screws to the
tensioner, then tighten the last screw ( x3 ).
8. Tighten screws [D] (
x3 ).
9. Reverse the rest of the removal procedure.
To Next Page
Loading...
Need help?
General
