Fax Option Installation
SM 3 D629
Fax Option
Type 5002
(D629)
4. Remove the FCU cover [A] ( x 3).
5. Remove the jumper [A] (set to OFF) and set it to
ON.
The machine may issue SC819, SC820
if the jumper is not set to "ON" correctly.
(Sometimes these SC codes are not
issued.)
The following step is for units installed in Brazil only!
6. For installation in Brazil, move the jumper switch (CN613) on the FAX board so that the edge
is anchored at “1”. (So that the middle pin and the “1” pin are covered.)
In its default position, the switch covers the middle and “3” pin.
7. Install the FCU [A] ( x 4; use the three screws
which were removed in step 3).
⇒
Rev. 11/15/2012
To Next Page
Loading...
