Ricoh D129 - Page 1046

Error Codes
D629 28 SM
Code Meaning Suggested Cause/Action
2-53 Snd msg() in the manual task
is an error because the
mailbox for the operation task
is full.
 The user did the same operation many
times, and this gave too much load to the
machine.
4-01 Line current was cut  Check the line connector.
 Check for line problems.
 Replace the FCU.
4-10 Communication failed
because of an ID Code
mismatch (Closed Network) or
Tel. No./CSI mismatch
(Protection against Wrong
Connections)
 Get the ID Codes the same and/or the
CSIs programmed correctly, then resend.
 The machine at the other end may be
defective.
5-00 Data reconstruction not
possible
Replace the FCU.
5-10 DCR timer expired  Replace the FCU.
5-20 Storage impossible because
of a lack of memory
 Temporary memory shortage.
 Test the SAF memory.
5-21 Memory overflow
5-23 Print data error when printing
a substitute rx or confidential
rx message
 Test the SAF memory.
 Ask the other end to resend the message.
5-25 SAF file access error  Replace an SD card or HDD.
 Replace the FCU.
6-00 G3 ECM - T1 time out during
reception of facsimile data
 Try adjusting the rx cable equalizer.
 Replace the FCU.
6-01 G3 ECM - no V.21 signal was
received
6-02 G3 ECM - EOR was received