System SP Tables-2
D129/D130 3-32 SM Appendix
026
Leading Edge 2nd Side: Special 3
C2b: [10 to 100 / 24 / 1
A]
C2c: [10 to 100 / 32 / 1
A]
Adjusts the transfer current for copying at leading edge the second side of
the paper (Special 3). Increase the current to separate the paper from the
drum properly in high humidity and high temperature conditions.
2602*
PTL Control (SSP)
Use this SP when an image problem occurs caused by the pick-off paws.
This SP is for the printing which target line speed is 230 or 180 mm/sec. Set
the PTL control (SP2603-001) to “1: ON” after installing the PTL. If the PTL
control is set to ON, the black line is come out due to exfoliation leave. Set
SP2911-002 (or 005, 008, 011) to “20” when using the PTL.
001
1st Side: OFF/ON [0 to 1 / 0 / 1]
Sets the PTL control setting for printing the first side of the paper.
002
1st Side: OFF Timing [-10 to 10 / 2 / 1]
Sets the PTL control time for printing the first side of the paper when
SP2602-001 is set to “1”.
003
2nd Side: OFF/ON [0 to 1 / 0 / 1]
Sets the PTL control setting for printing the second side of the paper.
004
2nd Side: OFF Timing [-10 to 10 / 2 / 1]
Sets the PTL control time for printing the second side of the paper when
SP2602-003 is set to “1”.
To Next Page
Loading...
