SP Mode Tables
1-907-015 Re-Feed Stop Posi E*
[-10 to 10 / 0 / 1mm/step]
Adjusts the reverse stop timing of the
range from the duplex entrance sensor
ON to the duplex clutch.
Makes it slower (+) or faster (-) than the
default.
1908
[Paper Timing Adj]
Adjusts the timing of paper feed. (A "+" setting broadens paper feed
interval, a “-” setting narrows paper feed interval.)
1-908-015 Junc Gate SOL:ON E*
[-10 to 10 / 0 / 1mm/step]
1-908-017 Junc Gate SOL:ON E*
1921
[Fact LeadEdge Reg]
Increasing a value: an image is moved to the trailing edge of paper.
Decreasing a value: an image is moved to the leading edge of paper.
1-921-011 By-Pass: Plain E*
[-4.0 to 4.0 / 0.0 / 0.1mm/step]
Reflects adjustment values with no
change.
1-921-012 By-Pass: Thick E*
[-4.0 to 4.0 / 0.0 / 0.1mm/step]
Adds on to the adjusted values of the
Plain paper.
1-921-013 By-Pass: Envelope E*
[-4.0 to 4.0 / 0.0 / 0.1mm/step]
Adds on to the adjusted values of the
Plain paper.
1-921-021 Tray1: Plain E*
[-4.0 to 4.0 / 0.0 / 0.1mm/step]
Reflects adjustment values with no
change.
1-921-022 Tray1: Thick E*
[-4.0 to 4.0 / 0.0 / 0.1mm/step]
Adds on to the adjusted values of the
Plain paper.
To Next Page
Loading...
