Ricoh M160 - Page 498

Main SP Tables-5
SM Appendix 3-85 M160/M161
Appendices:
SP Mode Tables
5515
[SC/Alarm Setting]
With NRS (New Remote Service) in use, these SP codes can be set to
issue an SC call when an SC error occurs. If this SP is switched off, the SC
call is not issued when an SC error occurs.
5-515-001
SC Call C*
[0 or 1 / 1 / 1/step]
0: OFF
1: ON
5-515-002
Service Parts Near End Call C*
5-515-003
Service Parts End Call C*
5-515-004
User Call C*
5-515-006
Communication Test Call C*
5-515-007
Machine Information Notice C*
5-515-008
Alarm Notice C*
5-515-009
Non Genuine Tonner Ararm C*
5-515-010
Supply Automatic Ordering
Call
C*
5-515-011
Supply Management Report
Call
C*
5-515-012
Jam/Door Open Call C*
5516
[Individual PM Part Alarm Call]
With @Remote in use, these SP codes can be set to issue a PM alarm call
when one of SP parts reaches its yield.
5-516-001
Disable/Enable Setting
(0:Not Send,1:Send)
C*
[0 or 1 / 1 / 1/step]
0: Not send
1: Send
5-516-004
Percent yield for triggering
PM alert
C* [1 to 255 / 75 / 1%/step]
5517
[Get Machine Information]
When SMC info collect is interrupt, retries during the time between receving
Request for obtaining SMC info, to value set with this setting.