Ricoh M160 - Page 633

Printer Service Mode
M160/M161 3-220 SM Appendix
1001 [Bit Switch]
005 Bit Switch 5 Settings 0 1
bit 0
Show "Collate Type", "Staple Type" and
"Punch Type" buttons on the operation
panel.
Disabled Enabled
If enabled, users will be able to configure a Collate Type, Staple Type, and
Punch Type from the operation panel. The available types will depend on
the device and configured options.
After enabling the function, the settings will appear under:
"User Tools > Printer Features > System"
bit 1 Multiple copies if a paper size or type
mismatch occurs
Disabled
(single
copy)
Enabled
(multiple)
If a paper size or type mismatch occurs during the printing of multiple
copies, only a single copy is output by default. Using this BitSw, the
device can be configured to print all copies even if a paper mismatch
occurs.
bit 2 Prevent SDK applications from altering
the contents of a job.
Disabled Enabled
If this switch is enabled, SDK applications will not be able to alter print
data. This is achieved by preventing SDK applications from accessing a
module called the "GPS Filter".
Note: The main purpose of this switch is for troubleshooting the effects of
SDK applications on data.
bit 3 [PS] PS Criteria Pattern3 Pattern1
Change the number of PS criterion used by the PS interpreter to
determine whether a job is PS data or not.
Pattern3: includes most PS commands.
Pattern1: A small number of PS tags and headers
bit 4
Increase max number of the stored jobs.
Disabled
(100)
Enabled
(750)