Remote Commands
R&S
®
FSW
788User Manual 1173.9411.02 ─ 19
11.5.9.1 Configuring the Measurement
The following remote commands measure the time domain power.
Useful commands for time domain power measurements described elsewhere
● CALCulate:MARKer:X:SLIMits:LEFT
● CALCulate:MARKer:X:SLIMits:RIGHT
● CALCulate:MARKer:X:SLIMits[:STATe]
Remote commands exclusive to time domain power measurements
CALCulate<n>:MARKer<m>:FUNCtion:SUMMary:AOFF................................................... 788
CALCulate<n>:MARKer<m>:FUNCtion:SUMMary:AVERage..............................................788
CALCulate<n>:MARKer<m>:FUNCtion:SUMMary:PHOLd................................................. 789
CALCulate<n>:MARKer<m>:FUNCtion:SUMMary[:STATe]................................................ 789
CALCulate<n>:MARKer<m>:FUNCtion:SUMMary:MEAN[:STATe]......................................789
CALCulate<n>:MARKer<m>:FUNCtion:SUMMary:PPEak[:STATe]..................................... 790
CALCulate<n>:MARKer<m>:FUNCtion:SUMMary:RMS[:STATe]........................................ 790
CALCulate<n>:MARKer<m>:FUNCtion:SUMMary:SDEViation[:STATe]...............................790
CALCulate<n>:MARKer<m>:FUNCtion:SUMMary:AOFF
This command turns all time domain power evaluation modes off.
Usage:
Event
CALCulate<n>:MARKer<m>:FUNCtion:SUMMary:AVERage <State>
This command switches on or off averaging for the active power measurement in zero
span in the window specified by the suffix <n>. If activated, a time domain value is cal-
culated from the trace after each sweep; in the end, all values are averaged to calcu-
late the final result.
The number of results required for the calculation of average is defined with [SENSe:
]AVERage:COUNt .
Averaging is reset by switching it off and on again.
Synchronization to the end of averaging is only possible in single sweep mode.
Parameters:
<State> ON | OFF
*RST: OFF
Configuring and Performing Measurements
To Next Page
Loading...
