Remote Commands
R&S
®
FSW
804User Manual 1173.9411.02 ─ 19
Useful commands for configuring EMI markers described elsewhere:
● CALCulate<n>:MARKer<m>[:STATe] on page 932
CALCulate<n>:DELTamarker<m>[:STATe] on page 930
● CALCulate<n>:MARKer<m>[:STATe] on page 932
CALCulate<n>:DELTamarker<m>[:STATe] on page 930
● CALCulate<n>:DELTamarker<m>:MREF on page 930
● CALCulate<n>:MARKer<m1>:LINK:TO:MARKer<m2> on page 931
CALCulate<n>:DELTamarker<m1>:LINK:TO:MARKer<m2> on page 929
CALCulate<n>:DELTamarker<m>:LINK on page 929
● CALCulate<n>:MARKer<m>:TRACe on page 932
Remote commands exclusive to configuring EMI markers
CALCulate:DELTamarker<m>:FUNCtion:FMEasurement:DETector.................................... 804
CALCulate:MARKer<m>:FUNCtion:FMEasurement:DETector............................................ 804
CALCulate:DELTamarker<m>:FUNCtion:FMEasurement:DETector <Detector>
This command selects the detector for a specific deltamarker during the final evalua-
tion.
If the deltamarker is not yet active, the command also turns the deltamarker on.
Parameters:
<Detector> OFF
no final measurement is performed
AVER
average detector
CAV
CISPR Average detector
CRMS
RMS Average detector
POS
maximum peak detector
QPE
quasipeak detector
*RST:
OFF
Manual operation: See "Final Test Detector" on page 301
CALCulate:MARKer<m>:FUNCtion:FMEasurement:DETector <Detector>
This command selects the detector for a specific marker during the final measurement.
If the marker is not yet active, the command also turns the marker on.
Configuring and Performing Measurements
To Next Page
Loading...
