R&S®SML / R&S®SMV03 Stereo Modulation (Option R&S SML-B5)
1090.3123.12 4.33 E-6
PIL
Description: Activates/deactivates the pilot tone.
Command: PIL=x
Query: PIL?
Response: x
Value range: 0|1
0 = Off
1 = On
Example: Command:
STEReo:DIRect “PIL=1“
The pilot tone is activated.
Query:
STEReo:DIRect? “PIL“
Response:
"1"
PIL-DEV
Description: Sets the pilot tone frequency deviation (max. deviation).
Command: PIL-DEV=xxxx
Query: PIL-DEV?
Response: xxxx
Value range: 0000 to 1000 (ASCII coded decimal numbers), corresponding to 0 Hz to 10 kHz
Example: Command:
STEReo:DIRect “PIL-DEV=1000“
Sets the frequency deviation of the pilot tone to 10 kHz.
Query:
STEReo:DIRect? “PIL-DEV“
Response:
"1000"
Note: A four-digit value must always be set. Leading zeros, if any, must also be specified.
PIL-PH
Description: Sets the pilot tone phase.
Command: PIL-PH=yxx
Query: PIL-PH?
Response: yxx
Value range: -5.0 to .0 to +5.0 (ASCII coded decimal numbers), corresponding to ±5.0
Example: Command:
STEReo:DIRect “PIL-PH=-33“
The pilot tone phase is set to -3.3
Query:
STEReo:DIRect? “PIL-PH“
Response:
"-33"
Note: A two-digit value must always be set with a sign ("+" or "-") in front of it. Leading zeros, if
any, must also be specified.
To Next Page
Loading...
