Rohde & Schwarz SML01 - Page 115

R&S®SML / R&S®SMV03 Stereo Modulation (Option R&S SML-B5)
1090.3123.12 4.37 E-6
RT
Description: Radio text
Command: RT= xx,y,ccccc…,cccc…
Query: RT?
Response: xx,y,ccccc…,ccccc…
Value range: xx = 00 to 15 (ASCII coded decimal numbers), number of retransmissions of
radio text message
y = 0|1 (A/B flag: If the A/B flag is set, the A/B bit in group 2A is toggled to signal
that a new radio text message will be transmitted.)
c = max. 64 characters, i.e. two texts of 64 characters each can be transmitted in
a radio text message
Example: Command:
STEReo:DIRect “RT=02,1,Testnachricht 123“
The radio text message "Test message 123" is transmitted.
Query:
STEReo:DIRect? “RT“
Reads the current radio text message.
Response:
"02,1,Test message 123"
SPS
Description: Scrolling Programme Service name
Der Programmname wechselt automatisch im angegebenen Zeitraster.
Command: SPS=tt,xxxxxxxx,yyyyyyyy,...
Value range: x,y = 8 ASCII characters
tt = 01 to 59 (time interval in seconds)
Max. 20 program service names of eight characters each can be entered.
Example: Command:
STEReo:DIRect “SPS=05,TEST0123,TEST4567“
The program service names "TEST0123" and "TEST4567" are alternately
transmitted at an interval of 5 seconds.
Note: An eight-digit value must be set for each program service name. Blank spaces, if any, must
also be entered, otherwise the value will not be accepted.
SRC
Description: Selects the signal source.
Command: SRC=x
Query: SRC?
Response: x
Value range: 0|1|2|3
0 = OFF
1 = external analog (via L and R inputs)
2 = external digital
3 = internal with LF generator
Example: Command:
STEReo:DIRect “SRC=1“
The external analog L and R inputs are selected as source.
Query:
STEReo:DIRect? “SRC“
Response:
"1"