7—Project and Drive Operations
106 www.RolandUS.com Roland VS-2400CD Owner’s Manual
Exporting to a VS-2480/VS-2480CD
• RSS PAN settings and V-Link Automix data are discarded when a VS-2400CD
project is exported as a VS-2480 project.
Exporting a VS-2400CD Project
1. Load the desired project into the VS-2400CD.
2. Hold down SHIFT and press F1 (PROJECT).
3. If “EXPORT” isn’t visible above F4, press PAGE until it is.
4. Press F4 (EXPORT). The PROJECT EXPORT screen appears.
5. Set the Verify and CD Speed parameters:
• Verify’s setting determines whether or not the VS-2400CD double-checks the
accuracy of the data it writes on your CD. Turning Verify on is always the safest
method, though it does cause the export to take a little longer.
• CD Speed—sets the speed at which the exported data is written to the CD. Try
the MAX setting to make the EXPORT process faster. If you experience
problems, try a slower setting.
6. Set the Save As parameter to select the type of V-Studio data the VS-2400CD
exports.
7. Export Track determines which of the project’s tracks are exported.
8. Press F5 (OK). The VS-2400CD asks if you want to save any recent changes you’ve
made to the current project before proceeding.
9. Press ENTER/YES to save any recent changes, or EXIT/NO to skip to exporting.
If you’re using a CD-RW disc that already contains data, the VS-2400CD asks if you
want to erase the disk. For details on the messages that may appear, see Page 344.
10. If a project is too large to fit on the medium you’re using, the VS-2400CD asks you
for additional media as needed. Insert the requested media and press ENTER/YES,
or press EXIT/NO to abort the procedure.
During a multi-CD export operation, the VS-2400CD asks for each disk twice: once to
label the disk, and once to actually write data on the disk.
PROJECT menu
F4 (EXPORT)
VS2400OMUS.book 106 ページ ２００６年２月２８日 火曜日 午前１１時１２分
To Next Page
Loading...
