21—Working with the VS-2400CD 0utputs
274 www.RolandUS.com Roland VS-2400CD Owner’s Manual
Track Direct Outs
You can route any odd/even pair of the VS-2400CD’s tracks directly to a pair of outputs
on the EZ ROUTING OUTPUT ASSIGN screen. By default, the screen is set up for bus
routing, so you’ll need to activate the track direct outs when you want to send tracks to
outputs without using busses. You can select whether the tracks’ signals are to be sent
to outputs before or after their track channel faders.
Track direct outs are a great way to transfer tracks via R-BUS and an RPC-1 PCI card to
a computer for editing or effect processing. It’s also easy to send tracks to a TASCAM
DA series recorder or ADAT multitrack recorder connected via R-BUS and DIF-AT to
the VS-2400CD.
Routing a Pair of Tracks to a Pair of Outputs
1. Press EZ ROUTING.
2. If “OUTPUT” isn’t above F3, press PAGE repeatedly until it is.
3. Press F3 (OUTPUT)—the OUTPUT ASSIGN screen appears.
4. Press
to select the TRACK DIRECT OUT parameter.
5. Turn the TRACK DIRECT OUT parameter on—the screen changes to show track
output routing connections.
On the OUTPUT ASSIGN screen, you can route any pair of tracks to the desired
pair of outputs. The output jack and connector pairs run along the top of the screen,
and the track pairs run up and down its right edge.
6. Use
or
to highlight the desired pair of output jacks or digital connectors.
7. Turn the Time/Value dial to choose the pair of tracks you want to route to the
selected output pair—as you turn the dial, the connection moves up and down the
display, showing you what’s currently routed to the selected pair of outputs.
When the track direct outs are turned on, Aux and Direct path output connections
aren’t available. If you need to send a combination of tracks and Aux or Direct paths to
outputs, send the tracks via Direct paths instead of the track direct outs—see Page 196.
When you do this, routings between busses and outputs are de-activated, though their
connections remain in place behind the scenes.
If you prefer, you can route tracks to outputs by dragging an output pair’s connection
box down to the desired track pair with your mouse.
When the track direct outs are active, the MASTER bus can’t be routed directly to
outputs. However, you can send it into the MONITOR bus, which can be.
In this illustration, we’ve
selected the R-BUS
connection.
Tracks 9 and 10 are
currently routed to the
first and second R-BUS
digital output channels.
VS2400OMUS.book 274 ページ ２００６年２月２８日 火曜日 午前１１時１２分
To Next Page
Loading...
