Roland VS-2400CD - Monitoring the Recording Busses Directly; Routing a Pair of Busses to the Stereo MONITOR Bus

21—Working with the VS-2400CD 0utputs
Roland VS-2400CD Owner’s Manual www.RolandUS.com 273
The output jack and connector pairs run along the top of the screen, and the bus
pairs run up and down its left edge.
4. Use  or  to select the desired pair of output jacks or digital connectors.
5. Turn the Time/Value dial to choose the desired pair of busses to be routed to the
selected output pair—as you turn the dial, the connection box moves up and down
the display, showing you what’s routed to the selected pair of outputs.
Routing a Pair of Busses to the Stereo MONITOR Bus
1. Press EZ ROUTING.
2. If “OUTPUT” isn’t above F3, press PAGE repeatedly until it is.
3. Press F3 (OUTPUT)—the OUTPUT ASSIGN screen appears.
The assignment of a pair of busses—or a stereo bus—to the stereo MONITOR bus
is shown by the MONITOR bus assignment junction at the left of the output
routing area on the OUTPUT ASSIGN screen as shown above.
4. Press  to highlight the MONITOR bus assignment junction.
5. Turn the Time/Value dial to choose the pair of busses to be sent to the stereo
MONITOR bus—as you turn the dial, the connection moves up and down through
the busses on the left side of the display, showing what’s being sent to the bus.
Monitoring the Recording Busses Directly
To listen to the recording busses (Page 57) directly without sending them through their
track channels, assign REC L/R to the MONITOR bus. When you do this:
• All 16 recording busses are combined into a single stereo signal for monitoring.
• You can adjust this stereo signal’s level using the REC ATT parameter.
If the TRACK DIRECT OUT parameter is turned on, turn it off to activate bus routing.
When you do this, routings between tracks and outputs are de-activated, though their
connections remain in place.
If you prefer, you can route busses to outputs by dragging an output pair’s connection
box down to the desired bus pair with your mouse.
The coaxial and optical digital outputs are always active, and carry the same signal.
MONITOR bus assignment is unaffected by the setting of the TRACK DIRECT OUT
parameter—you can route signals to the MONITOR bus at any time.
In this illustration, we’ve
selected the MONITOR
bus assignment junction,
and the stereo MASTER
bus is selected as the
signal being sent to the
stereo MONITOR bus.
MONITOR bus
assignment
junction
VS2400OMUS.book 273 ページ ２００６年２月２８日 火曜日 午前１１時１２分