4—Setting Up and Basic Operations
72 www.RolandUS.com Roland VS-2400CD Owner’s Manual
Entering a New Name Using the VS-2400CD Controls
1. Press
to select the first character in the naming box if it isn’t already selected.
2. Turn the Time/Value dial to select the desired first character—a box appears around
the currently selected character in the area below the naming box.
3. Press
to select the next character.
4. Turn the Time/Value dial to select the second character in the new name.
5. Repeat Steps 3 and 4 until you’ve entered the entire new name.
6. When you’re done, press F5 (OK).
Entering a New Name from a Keyboard
1. Press
to select the first character in the naming box if it isn’t already selected.
2. Type the desired name.
3. Press F5 (OK).
Naming Tools
The F buttons beneath the naming screen provide tools you may want to use as you
create a name.
Entering Numbers with the Numeric Keypad
In parameter boxes that contain project time locations, you can enter the desired
number using the VS-2400CD numeric keypad. To do this:
1. Press NUMERICS. It lights—and ENTER/YES and EXIT/NO flash—to indicate that
the keypad is active.
2. Press
or
to select the part of the number you want to enter.
The project-naming screen provides some additional elements, including information
about the project and an area into which you can enter comments about the project.
Press: To:
F1 (HIST) recall with each press one of the names you’ve entered since
powering up.
F2 (BackSp) delete the character to the left of the currently selected character.
F3 (DELETE) erase the currently selected character and move all following
characters to the left by one position.
F4 (INSERT) add a blank space before the currently selected character, moving all
following characters one position to the right.
F5 (OK) assign the currently entered text to the item you’re naming.
F6 (CANCEL) leave the naming screen without assigning a new name.
VS2400OMUS.book 72 ページ ２００６年２月２８日 火曜日 午前１１時１２分
To Next Page
Loading...
