Roland VS-2400CD - Multi-Channel View FX Return Channels

33—VGA Main Display Mixer Views
434 www.RolandUS.com Roland VS-2400CD Owner’s Manual
Multi-Channel View FX Return Channels
1. ASSIGN Selector
2. EFFECT Algorithm Display
3. AUX Send Sliders
4. DIR (DIRECT) 1-8 Selector
5. MUTE (M) Button
6. SOLO (S) Button
8. GRP (GROUP) Selector
You can click the ASSIGN selector and choose the
Aux bus that’ll carry signals to the FX return
channel’s effect processor.
The EFFECT algorithm display shows the
corresponding effect processor’s currently
selected effect algorithm. Click the display to
open the Algorithm View screen from which you
can select a different effect patch, or edit the
current patch.
Set the amount of the channel’s signal sent to an Aux bus by adjusting
the corresponding AUX send slider. With linked Aux busses, a panning
handle replaces the even-numbered Aux bus’s slider (Page 425).
To route the channel’s signal to a Direct path, click the desired bus’s
number.
To mute the channel, click this button so it’s lit. To un-mute the channel,
click the button again.
To solo the channel, click the SOLO button to light it. To un-solo the
channel, click the button again.
To assign the channel to a fader group, click beneath “GRP” and
select the desired fader group from the pop-up menu.
1.
2.
8.
9.
10.
11.
4.3.
5.
6.
7.
224
215
226
225
138
138
224
VS2400OMUS.book 434 ページ ２００６年２月２８日 火曜日 午前１１時１２分