Roland VS-2400CD - The EZ ROUTING OUTPUT ASSIGN Screen; Making Connections on the EZ ROUTING PATCH BAY Screen

22—EZ Routing
Roland VS-2400CD Owner’s Manual www.RolandUS.com 279
On the PATCH BAY screen, you can route the following jacks and connectors to input
channels:
• the 16 analog input jacks (XLR and 1/4”)
• The R-BUS connectors’ 8 digital channels
• the coaxial digital connector or the optical digital connector (Page 127)
You can also turn phantom power on or off for the XLR input jacks, and activate the
desired digital inputs on this screen, as described on Page 126 and Page 127,
respectively.
Making Connections on the EZ ROUTING PATCH BAY Screen
1. Use  ,  ,  or  to select the desired pair of input channels.
2. Turn the Time/Value dial to create the desired connection.
Chapter 9 describes in detail how to route inputs to input channels—see Page 132.
The EZ ROUTING OUTPUT ASSIGN Screen
On the EZ ROUTING OUTPUT ASSIGN screen, you can route any of the VS-2400CD’s
busses or tracks to output jacks or connectors. The screen’s appearance changes slightly
for the two types of routing.
For the purposes of routing, input jacks and connectors and input channels are treated
as odd/even pairs. These pairs cannot be altered.
The gray arrows at
the left edge of the
screen show the
direction in which
signal is flowing.
Input channel
inputs
Input jacks and
connectors
Outputs
Busses
Outputs
Tracks
When routing busses When routing tracks
VS2400OMUS.book 279 ページ ２００６年２月２８日 火曜日 午前１１時１２分