Roland VS-2400CD - Turning on Surround Mode

24—Surround
Roland VS-2400CD Owner’s Manual www.RolandUS.com 311
Turning on Surround Mode
To create a Surround mix, you must be in Surround mode.
1. Hold down SHIFT and press F4•UTILITY.
2. If “Surrnd” isn’t visible above F3, press PAGE until it is.
3. Press F3 (Surrnd) to view the SURROUND screen.
4. Set SURROUND MIX MODE to the desired Surround format.
5. Turn the SURROUND MIX Sw parameter on. The VS-2400CD reminds you that it’s
about to re-configure your Aux busses, and asks if you’re sure you want to switch to
Surround mode.
6. Press ENTER/YES to proceed, or EXIT/NO to cancel the activation of Surround
mode.
If you pressed ENTER/YES in Step 6, the VS-2400CD reminds you that your current
channel panning settings will also be affected by the switch to Surround mode.
7. Press ENTER/YES to proceed, or EXIT/NO to cancel the change into Surround
mode.
When you switch to Surround mode, connections are broken between any Aux busses
required by the selected Surround format and the VS-2400CD’s internal effects in order
to prevent confusion. You can re-route the Aux busses to the effects if you wish
(Page 280).
This message also appears if you change Surround formats when Surround mode is
already turned on.
If you’ve got mixer settings you’d like to preserve, press EXIT/NO, save them as a scene
and then activate Surround mode.
VS2400OMUS.book 311 ページ ２００６年２月２８日 火曜日 午前１１時１２分