17—Working with FX Channels
224 www.RolandUS.com Roland VS-2400CD Owner’s Manual
The Main FX Return CH EDIT Screen
1. Press AUX 1-8/FX 1-4 to activate channel strip control of FX Return Channels 1-4.
2. Press the desired FX return channel’s CH EDIT button—its main CH EDIT VIEW
screen appears.
1. ASSIGN
The ASSIGN selector designates the Aux bus that carries signals to the FX
return channel’s effect processor. This parameter interacts with, and
reflects the setting of, the EZ ROUTING EFFECT screen described on
Page 204.
2. EFFECT Algorithm Display
The EFFECT algorithm display shows the algorithm on
which the effect’s currently selected patch is based. When
the display is selected, the ENTER/YES button flashes—
press the ENTER/YES button to jump to the effect’s
Algorithm View screen (Page 215).
3. MONO Sw
The MONO Sw (“Mono Switch”) allows you to collapse the left and right
sides of the stereo effect into a mono signal. To restore the effect to stereo,
turn Mono Sw off.
4. GROUP
You can assign the effect’s output to any of the VS-2400CD’s 12 fader groups that
allow you to control the levels of multiple input, track and/or FX return channels. The
parameter operates in exactly the same way as the input and track channel GROUP
parameter—see Page 150.
When the effect’s output is mono, you can use its BAL (Page 225) parameter to pan the
effect to the desired location.
You can control the level of the 12 faders groups using the VS-2400CD’s faders. See
“Controlling Fader Group Levels with the Channel Strips” on Page 135.
6.
1.
2.
3. 4.
7.
5.
8.
10.
9.
11.
12.
13.
VS2400OMUS.book 224 ページ ２００６年２月２８日 火曜日 午前１１時１２分
To Next Page
Loading...
