EasyManua.ls Logo

Roland VS-2400CD - Connecting an MB-24 Level Meter; Replacing the VS-2400 Cds Battery

Roland VS-2400CD
508 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
28—Expanding the VS-2400CD
Roland VS-2400CD Owner’s Manual www.RolandUS.com 377
Connecting an MB-24 Level Meter
1. With the power to the VS-2400CD and the MB24 turned off, connect the
VS-2400CD’s MIDI OUT to the MB-24’s MIDI IN using a MIDI cable.
2. If you want to connect another MIDI device to the VS-2400CD, connect its input to
the MB-24’s MIDI THRU jack using a MIDI cable.
3. Turn on the power to your devices.
Replacing the VS-2400CD’s Battery
The VS-2400CD contains a lithium battery that powers its time-keeping features, and
also provides the power for the area of the VS-2400CD’s memory that stores certain
parameter values. When the battery weakens, the VS-2400CD’s time-keeping features
may not operate correctly, and it may not properly remember various settings upon
power-up. If the battery needs to be replaced, the VS-2400CD shows the following
message when you power up:
Installation Procedure
1. Power down the VS-2400CD (Page 78), saving any recent changes you’ve made to
the currently loaded project.
2. Turn off all connected devices, and disconnect all cables from VS-2400CD.
MB-24 cannot be attached VS-2400CD unit itself. MB-24 should be installed in your
system rack with the rack mount adaptors included in its package.
For details refer to MB-24 Owner’s Manual “Connecting the mixing processor
(VM-7100/VM-7200) and the MB-24” (Page 11, step 1).
When using the MB-24, set the VS-2400CD’s MIDI OUT/THRU parameter to Out
(Page 286). To learn how to configure the meter bridge, see the “EXTERNAL LEVEL
METER” parameter section on Page 354.
Use only the specified type (model no. CR2032) of lithium battery. Be sure to insert it as
directed (to ensure correct polarity).
Before turning the VS-2400CD upside-down to install a new battery, obtain some
newspapers or magazines and place them under the four corners of the VS-2400CD, or
at both ends, to prevent damage to the buttons and controls. Position the VS-2400CD
carefully to avoid scratching or damaging it.
When installing a new battery, follow the precautions listed on Page 373.
VS2400OMUS.book 377 ページ 2006年2月28日 火曜日 午前11時12分

Table of Contents

Other manuals for Roland VS-2400CD

Related product manuals