25—Automix
318 www.RolandUS.com Roland VS-2400CD Owner’s Manual
To load an Automix:
1. Press F3 (LOAD)—the Automix loading screen appears.
2. Highlight the Automix you want to load.
3. Press F5 (OK)—the VS-2400CD asks “Load Automix Pattern?”
4. Press ENTER/YES to proceed or EXIT/NO to cancel the loading.
The F2 (ERASE) Button
To erase all of the currently loaded Automix data at once, press F2 (ERASE).
Activating Automix Mode
1. Stop project playback.
2. Press AUTOMIX—it lights solidly, but doesn’t flash, to show Automix
mode is active.
3. To turn Automix mode off, press AUTOMIX again—its light turns off.
The AUTOMIX STATUS Buttons
When Automix mode is active, each CH EDIT/SELECT/AUTOMIX STATUS button can
set the status of its corresponding Automix track.
Using the AUTOMIX STATUS Buttons
1. Press the FADER button for the group of channels containing the one that
corresponds to the desired Automix track.
2. If Automix isn’t already solidly lit—press AUTOMIX.
3. While holding down AUTOMIX, press the desired AUTOMIX STATUS button.
Each press changes the Automix track’s status, as reflected by the button’s lighting
state.
When you load an Automix, it replaces the currently loaded Automix. If you don’t want
to lose your current Automix, makes sure to save it before loading a different one.
When you erase Automix data, you erase only the currently loaded Automix data. Any
Automix you’ve saved remains intact and can still be loaded.
For the remainder of this chapter, we’ll refer to these buttons as simply “AUTOMIX
STATUS” buttons.
You can change the status of the MASTER bus, Direct path and effect patch Automix
tracks only on the AUTOMIX screen.
VS2400OMUS.book 318 ページ ２００６年２月２８日 火曜日 午前１１時１２分
To Next Page
Loading...
