33—VGA Main Display Mixer Views
424 www.RolandUS.com Roland VS-2400CD Owner’s Manual
6. AUTOMIX STATUS (A) Button
7. PAN Knob
8. Channel Fader
9. LINK Switch
Master Block Strips
The Master Block strips contain Direct path parameters (Page 202) and Aux bus
controls (Page 199).
Direct Path Parameters
1. Source
Click Source and choose the signal you want to assign to the Direct path.
2. Pre/Post Switch
This sets the Direct path to receive a channel’s signal before or after the channel fader.
3. AUTOMIX STATUS (A) Button
When Automix is on, repeatedly click this button to set the Direct path’s Automix
status.
4. Final Level Knob
Drag this knob up or down to set the final level of the Direct path.
When Automix is turned on, repeatedly click the AUTOMIX STATUS
button to set the channel’s Automix status.
Set the stereo position of the channel in the main MASTER bus mix by
dragging the PAN knob up or down as desired.
The position of the channel fader sets the level of signal coming out of
the channel. Moving it is the same as moving the channel’s physical
fader on the VS-2400CD. The channel’s level is displayed below the
fader.
LINK combines the CH EDIT ChLink and F.LINK parameters. Click
to the right of “LINK” and select the desired type of linking from the
pop-up menu, or turn off linking. The LINK switch occupies the
combined lower edge of both of the channels it controls.
318
152
150
147, 151
1.
2.
3.
4.
VS2400OMUS.book 424 ページ ２００６年２月２８日 火曜日 午前１１時１２分
To Next Page
Loading...
