13—Operating the Hard Disk Recorder
180 www.RolandUS.com Roland VS-2400CD Owner’s Manual
Storing a Locator
1. Press LOCATOR•BANK if it’s not already lit.
Each locator bank contains 10 memory slots, numbered from 0-9, in which a locator
can be stored. These memory slots correspond to the 0-9 buttons on the numeric
keypad. When a locator’s been stored in a slot, its button lights on the keypad.
2. Press any 0-9 button on the keypad to store the locator in the corresponding
memory slot. If you’d like to store the locator in a different locator bank, see
“Changing Locator Banks” and press the desired button in the selected bank.
3. If a memory slot already contains a locator, and you want to store a new locator
there, you’ll have to first clear the older locator. See “Clearing a Locator” below.
Recalling a Locator
1. Press LOCATOR if it’s not already lit.
2. If the currently selected locator bank contains the locator you want, press the
locator’s lit button on the keypad. To recall a locator from another bank, follow the
instructions in “Changing Locator Banks” and press its button in the selected bank.
Changing Locator Banks
1. Press LOCATOR if it’s not already lit. If any locators are stored in the currently
selected locator bank, their buttons light on the numeric keypad.
2. While holding down SHIFT, press LOCATOR•BANK. The button for the currently
selected bank lights solidly, and the other keypad buttons flash.
3. Press 0-9 to select the desired locator bank—if locators are stored there, their
numbers light on the keypad.
Clearing a Locator
1. Press LOCATOR if it’s not already lit. If you’d like to clear a locator from a different
bank, see the instructions in “Changing Locator Banks” first.
2. While holding down CLEAR, press the desired locator’s button on the keypad. The
locator is cleared from that memory slot, and the button’s light turns off.
Other Locator Operations
Editing Locators
You can edit locators on the UTILITY menu’s LOCATE screen. You can name them,
clear them, create them, change their positions and jump to them from this screen.
1. Hold down SHIFT and press F4•UTILITY.
2. Press PAGE repeatedly until “LOCATE” appears over F5.
3. Press F5 (LOCATE).
You can store locator’s while a project’s playing or when it’s stopped.
VS2400OMUS.book 180 ページ ２００６年２月２８日 火曜日 午前１１時１２分
To Next Page
Loading...
