Roland VS-2400CD - Powering up; What Happens During the VS-2400 Cds Power-Up

4—Setting Up and Basic Operations
Roland VS-2400CD Owner’s Manual www.RolandUS.com 63
Making Power Connections
Connect one end of the supplied AC power cable to a grounded AC outlet, and the
other to the VS-2400CD’s AC IN jack—use only the supplied AC cable. Connect all
other devices’ power cables as recommended in their documentation.
Powering Up
It’s important that you power up the VS-2400CD and any equipment to which it’s
attached in the following order to prevent damage to your equipment and to make sure
the VS-2400CD recognizes everything you’ve connected to it.
1. Turn on everything connected to the VS-2400CD except your monitors or
monitoring system. This includes devices connected to the VS-2400CD via analog
connections or digitally and your VGA monitor.
2. Turn on the VS-2400CD by pressing its rear-panel POWER switch to its On position.
When the Home display—shown here—appears, the VS-2400CD power-up sequence
is complete.
This takes a few moments, as explained in the next section.
3. Turn on your monitor speakers or monitoring system.
What Happens During the VS-2400CD’s Power-Up
When you turn the VS-2400CD on, it performs a few important tasks that help ensure
its successful operation. It:
• performs some diagnostic routines to make sure everything’s working properly.
• sets up the available effects.
• re-loads the project that was loaded at power-down. (When you turn on the
VS-2400CD for the first time, this is the “Chemistry” demo.) As a project loads, the
faders move to their last-saved positions and the project’s settings are restored.
Once the connections have been completed (Page 64), turn on power to your various
devices in the order specified. By turning on devices in the wrong order, you risk
causing a malfunction and/or damage to speakers and other devices.
This unit is equipped with a protection circuit. A brief interval (a few seconds) after
power up is required before the unit will operate normally.
If you need to turn off the power completely, first turn off the POWER switch, then
unplug the power cord from the power outlet. See “Power Supply” on Page 5.
In the following steps, allow each piece of equipment to finish its power-up sequence
before proceeding to the next step.
VS2400OMUS.book 63 ページ ２００６年２月２８日 火曜日 午前１１時１２分