31—VGA Main Display Home Screen
406 www.RolandUS.com Roland VS-2400CD Owner’s Manual
20. Status Toggles
Beneath the track control areas are five status toggle buttons. You can click each button
to toggle the setting of the entire column of buttons directly above it.
The Playlist’s Measure Bar
Just above the playlist is a gray strip called the “measure bar.” The lines in the bar show
the project measures as defined by the project tempo map (Page 298). The time bar also
contains markers, CD track markers, edit point flags, punch points and loop points.
You can place any of these items at the desired locations using onscreen tools. To learn
how to place:
•
markers
—see “TAP” on Page 395.
•
edit points
—see Page 408.
•
Auto Punch points
—see Page 393.
•
loop points
—see Page 393.
You can:
•
reposition an object in the measure bar
—by moving your cursor over the object so the
cursor becomes a pointing finger, and then dragging to the desired new location.
•
clear an object in the measure bar
—holding down CLEAR on the VS-2400CD,
positioning the mouse cursor over the object until it turns into a pointing finger,
and then clicking the object.
Click this status toggle: To:
MUTE un-mute all currently muted tracks.
SOLO un-solo all currently soloed tracks.
AUTOMIX STATUS set the status of all Automix tracks to the same value.
TRACK STATUS set the TRACK STATUS of all tracks to the same value.
MUTE status toggle TRACK STATUS toggle
SOLO status toggle
AUTOMIX STATUS toggle
Marker
Auto Punch Points Loop Points
Edit Points
IN OUT FROM TO
Punch in Punch out Loop endLoop start
When Auto Punch is on, a red bar
connects the red punch points.
When looping is on, a blue loop box
connects the blue start and end points.
CD Track Marker
VS2400OMUS.book 406 ページ ２００６年２月２８日 火曜日 午前１１時１２分
To Next Page
Loading...
