31—VGA Main Display Home Screen
404 www.RolandUS.com Roland VS-2400CD Owner’s Manual
8. FADER (LEV) Slider
9. PAN Slider
10. PHASE Button
11. ATT Slider
12. GROUP (GRP) Selector
13. LINK Switch
14. FX Ins Selector
15. DYNAMICS (DYN) Switch and Overview
Drag the FADER slider to set the track channel’s CH EDIT FADER
parameter—this serves the same purpose as moving the channel’s
physical fader. The readout to the right of the slider shows the track
channel’s output level in dB.
Adjust the track channel’s stereo position by dragging the PAN
slider as desired—the current pan position is shown to the right of
the slider. When you move the slider, you’re adjusting the track
channel’s CH EDIT PAN parameter value.
Click “NRM” or INV” in the PHASE button to reverse the phase
polarity of the track channel’s signal.
Set the ATT slider to adjust the level of the signal coming from the
hard disk recorder into the track channel. The signal’s level is shown
to the right of the slider.
To assign the track channel to a fader group, click to the right of
“GRP” and select the desired fader group from the pop-up menu.
LINK combines the CH EDIT ChLink and F.LINK parameters. Click
to the right of “LINK” and select the desired type of linking from the
pop-up menu or turn off linking.
Turn on the track channel’s dynamics processor by clicking the DYN
switch. The current dynamics shape is shown graphically next to the
switch—when the switch is on, the shape becomes blue.
You set up a channel’s dynamics processing by drawing the desired shape with your
mouse in the CH VIEW screen as described on Page 417.
150
152
150
148
150
147, 151
149
VS2400OMUS.book 404 ページ ２００６年２月２８日 火曜日 午前１１時１２分
To Next Page
Loading...
