EasyManua.ls Logo

Roland VS-2400CD - Current Channel Display; PAN Knobs; Meters Display

Roland VS-2400CD
508 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8—The Home Screen
116 www.RolandUS.com Roland VS-2400CD Owner’s Manual
Current Channel Display
The current channel display shows you the name of the input, track or FX return
channel that’s most recently been selected for editing (“Selecting a Channel for
Editing” on Page 134).
PAN Knobs
The PAN knobs show the PAN settings in the MASTER mix for the channels currently
selected with the FADER buttons (Page 134). You can drag any of these virtual knobs left or
right to shift the corresponding channel’s signal leftward or rightward, respectively.
Meters Display
The meters display shows the levels of your signals. The meter switches at the bottom
of the display select the signals to be displayed—they’re described on Page 120. In the
illustration above, F3 (TR Mix), for “Track Mixer, has been pressed and is currently
highlighted at the bottom of the display (not shown).
The meters display often shows the meters for more than one set of signals at a time, as
in the illustration above. Each group of meters is labeled—the label appears just above
the meters. The numbers at the bottom of the meters display identify each meter’s
signal. In this illustration, the meters to the left are showing the levels of the 24 tracks.
The meters to the right show the levels of the stereo MONITOR and MASTER busses.
The meters display can be replaced by the fader/pan display, described on Page 123. If
the meters display isn’t visible, press PAGE on the VS-2400CD until the meter switches
appear, and then select the desired meters’ display view (Page 120).
There’s
always
an input, track, Aux master or FX return channel selected in the
VS-2400CD, even if you’ve just powered up and haven’t manually selected one. After
power-up, Track Channel 1 is selected.
As described on Page 69, you can click on a channel’s name in the current channel
display to access the Channel Pop-Up menu.
or... or...
Pre/post indicatorMeter group label Meter group labels
The vertical black
bars are the
meters.
Meter names
VS2400OMUS.book 116 ページ 2006年2月28日 火曜日 午前11時12分

Table of Contents

Other manuals for Roland VS-2400CD

Related product manuals