Roland VS-2400CD - Track Channel Strips

33—VGA Main Display Mixer Views
426 www.RolandUS.com Roland VS-2400CD Owner’s Manual
Track Channel Strips
1. DYNAMICS (DYN) On/Off
2. EQ On/Off
3. AUX Send Sliders
4. MUTE (M) Button
5. SOLO (S) Button
6. AUTOMIX STATUS (A) Button
7. PAN Knob
8. TRACK STATUS Button
9. Channel Fader
Click this button to turn the channel’s dynamics processor on—when
the button’s lit—or off. See Page 149.
To turn the channel’s EQ on or off, click this button. When it’s lit, the
EQ’s on. See Page 149.
Set the amount of the channel’s signal sent to an Aux bus by adjusting
the corresponding AUX send slider. With linked Aux busses, a panning
handle replaces the even-numbered Aux bus’s slider (Page 425).
To mute the channel, click this button so it’s lit. To un-mute the channel,
click the button again.
To solo the channel, click the SOLO button to light it. To un-solo the
channel, click the button again.
When Automix is turned on, repeatedly click the AUTOMIX STATUS
button to set the channel’s Automix status.
Set the stereo position of the channel in the main MASTER bus mix by
dragging the PAN knob up or down as desired.
Repeatedly click the TRACK STATUS button to set status of the
corresponding hard disk recorder track. This is the same thing as
pressing the track’s TRACK STATUS button on the VS-2400CD.
The position of the channel fader sets the level of signal coming out of
the channel. Moving the onscreen fader is the same as moving the
channel’s physical fader on the VS-2400CD.
1.
2.
3.
5.
7.
9.
10.
4.
6.
8.
148
138
138
318
152
172
150
VS2400OMUS.book 426 ページ ２００６年２月２８日 火曜日 午前１１時１２分