27—UTILITY Menu Parameters
Roland VS-2400CD Owner’s Manual www.RolandUS.com 359
OPERATION DISPLAY
DATE/REMAIN Sw
You can replace the clock in the upper right-hand corner of the VS-2400CD’s LCD
display with a readout of how much free space remains on the currently selected drive.
When you set DATE/REMAIN Sw to:
•
Date
—the VS-2400CD’s calendar/clock is displayed.
•
Remain
—the amount of free space left on the current drive is shown.
REMAIN DISPLAY TYPE
When the display is showing the remaining space on the currently selected drive—see
DATE/REMAIN Sw above— REMAIN DISPLAY TYPE sets the manner in which that
information’s presented:
•
Time
—shows the remaining recording time based on the current sample rate and
recording mode.
•
CapaMB
—shows the remaining free space in megabytes (MB).
•
Capa%
—shows the free space remaining as a percentage of the original space.
•
Event
—shows the remaining number of free project events.
PROJECT
DIGITAL I/O
MASTER CLOCK
To learn about setting the MASTER CLOCK parameter, see “Designating the Master
Clock for Digital Audio Input” on Page 129.
DITHER
If you’re sending audio to a connected external digital recorder that records at a lower
bit depth than the VS-2400CD (Page 128), you can dither the VS-2400CD’s output signal
so that it sounds its best at the bit depth the external device is using. Dithering adds an
inaudible veil of noise to the signal in order to mask audio artifacts that are introduced
when bits are discarded as audio travels from a higher bit-rate device to a lower one. To
set DITHER, select the bit depth of the external digital device.
VS2400OMUS.book 359 ページ ２００６年２月２８日 火曜日 午前１１時１２分
To Next Page
Loading...
