26—Mastering and CD-R/RW Operations
340 www.RolandUS.com Roland VS-2400CD Owner’s Manual
You’ll find the process of placing CD track markers much simpler if the numbers of the
CD track markers you place correspond to the numbering of the CD’s audio selections.
There are a couple of things you can do to make this happen.
Delete all of the project’s other markers
When you do this, your marker numbering starts with a clean slate. If you don’t want to
lose your markers, make a second copy of the project (Page 97). Remove the markers—
and burn your CD—from one of the project copies. See Page 184 to learn how to delete
all of a project’s markers.
Place a pair of dummy markers in the first selection
Since your CD burner ignores the VS-2400CD’s normal project markers, you can place
two “dummy” markers somewhere in the middle of the first selection—it doesn’t
matter where, as long as they’re at least four seconds after the start of the selection and
at least four seconds before its end. These two markers push the remaining CD track
marker numbers back into line with the CD’s track numbers. To use our example again:
Placing CD Track Markers
1. Press HOME•DISPLAY to view the Home screen.
2. Position the now line at the beginning of the second selection on your mastering
tracks. (Remember, the first selection’s CD track marker is set automatically).
3. While holding down CD-RW/MASTERING, press TAP to place
the CD track marker.
4. Repeat Steps 1 and 2 for any other CD track markers you want to
place in your mastering tracks.
When you’re done, you can jump from marker to marker to check their positions using
the PREVIOUS and NEXT buttons—see “Using PREVIOUS and NEXT” on Page 183. If
you need to clear and re-place a CD track marker, use PREVIOUS or NEXT to move the
now line to the marker, hold down CLEAR and press TAP.
Location: CD Track Marker is numbered as: CD Track:
Beginning of Song #1 none needed—placed automatically 1
Middle of Song #1 (Normal Marker #000)
(ignored by CD-R/RW)
Middle of Song #1 (Normal Marker #001)
(ignored by CD-R/RW)
Beginning of Song #2 002c 2
Beginning of Song #3 003c 3
Beginning of Song #4 004c 4
Use the VS-2400CD’s Scrub feature (Page 178) to place the now line as precisely as you
can, about 15 frames before the start of the selection’s audio. The placement of the CD
track marker determines what happens when a listener selects the track on a CD
player, so make sure you’ve set the CD track marker where you want it.
+
VS2400OMUS.book 340 ページ ２００６年２月２８日 火曜日 午前１１時１２分
To Next Page
Loading...
Need help?
General
