25—Automix
322 www.RolandUS.com Roland VS-2400CD Owner’s Manual
Snapshot Recording of Parameter Values
A snapshot registers the position of the now line and captures the
current parameter values on all Automix tracks that are Write-
enabled. When you play back the project with Automix turned on—
and the Automix tracks set to play back—the parameter values
stored in the snapshot are recalled when the now line reaches the
location at which the snapshot was taken.
Taking a Snapshot
1. Move the now line to the location at which you want to take a snapshot.
2. If Automix isn’t already turned on, press AUTOMIX so that it lights solidly.
3. Hold down AUTOMIX and press the AUTOMIX STATUS button for any Automix
track whose settings you want to capture so that the button flashes to signify that
the Automix track is in Write mode.
4. While holding down AUTOMIX, press AUTOMIX REC—AUTOMIX starts flashing
to signify that it’s ready to take the snapshot.
5. While holding down AUTOMIX, press TAP—the current parameter values for the
Write-enabled tracks are captured in the snapshot.
6. Hold down AUTOMIX and press REC so that AUTOMIX lights solidly to show it’s
no longer ready to record.
7. Hold down AUTOMIX and press the AUTOMIX STATUS button for each Write-
enabled Automix track to make it solidly lit for playback.
Playing Back Automix Data
To play back Automix data:
1. If AUTOMIX isn’t lit solidly, press it so that it is to show that Automix mode is on. If
it’s flashing, hold down AUTOMIX and press REC so that AUTOMIX lights solidly.
2. Hold down AUTOMIX and set the AUTOMIX STATUS button for each of your
Automix tracks to light it solidly so it plays back.
3. Play the project.
Editing Automix Data
Automix Editing Concepts
The AUTOMIX EDIT Screen
Automix editing takes place on the AUTOMIX EDIT screen. To get there:
1. While holding down SHIFT, press AUTOMIX.
2. Press F1 (EDIT)—the AUTOMIX EDIT screen appears.
VS2400OMUS.book 322 ページ ２００６年２月２８日 火曜日 午前１１時１２分
To Next Page
Loading...
